WINDOW FILMS CARE & MAINTENANCE

Thank you for your confidence in Cool N Lite® window films. To maximize the life of your high tech window film, please follow these instructions for proper care and maintenance.


IMMEDIATELY AFTER INSTALLATION

Drying time

During the film installation, our skilled technicians will remove as much of the installation fluid as possible, but a small amount will still remain. This may result in small water bubbles appearing and/ or a slightly cloudy view. This is normal and should be expected. The water bubbles and cloudy view will disappear over time.

Film type and climate conditions will determine the drying time you experience. Warm weather and direct sunlight will shorten the drying time, while cooler climates, cloudy conditions and thicker films may prolong it. Drying may vary from a few days to a month. The trapped moisture WILL eventually dry out completely.

 

Cleaning Instructions

Always use fresh clean soft materials to wash and dry your window film surfaces. Do not use any window cleaners. A soft cloth or a clean synthetic sponge is recommended for washing the window film followed by another clean soft cloth or soft rubber squeegee for drying.

To avoid scratching the film, do not use bristle brushes, abrasive scrubbing sponges, or any cleaning materials that may have been contaminated with dirt particles, as is commonly the case when washing interior and exterior windows with the same cleaning materials.

Some brands of paper towels are coarse enough to put fine scratches in the film, even films with scratch resistant, protective hard coat finish. While these scratches may be too thin to be seen at the beginning, they can damage the polished look of the film over time.